Linux Programmers Manual
Aliases: s390_pci_mmio_read(2), s390_pci_mmio_read(2), s390_pci_mmio_read(2)
s390_pci_mmio_write, s390_pci_mmio_read - transfer data to/from PCI MMIO memory page
int s390_pci_mmio_write(unsigned long mmio_addr, void *user_buffer, size_t length); int s390_pci_mmio_read(unsigned long mmio_addr, void *user_buffer, size_t length);
The s390_pci_mmio_write() system call writes length bytes of data from the user-space buffer user_buffer to the PCI MMIO memory location specified by mmio_addr. The s390_pci_mmio_read() system call reads length bytes of data from the PCI MMIO memory location specified by mmio_addr to the user-space buffer user_buffer.
These system calls must be used instead of the simple assignment or data-transfer operations that are used to access the PCI MMIO memory areas mapped to user space on the Linux System z platform. The address specified by mmio_addr must belong to a PCI MMIO memory page mapping in the caller’s address space, and the data being written or read must not cross a page boundary. The length value cannot be greater than the system page size.
On success, s390_pci_mmio_write() and s390_pci_mmio_read() return 0. On error, -1 is returned and errno is set to one of the error codes listed below.
|EFAULT||The address in mmio_addr is invalid.|
|EFAULT||user_buffer does not point to a valid location in the caller’s address space.|
|EINVAL||Invalid length argument.|
|ENODEV||PCI support is not enabled.|
These system calls are available since Linux 3.19.
This Linux-specific system call is available only on the s390 architecture. The required PCI support is available beginning with System z EC12.
Glibc does not provide a wrapper for this system call, use syscall(2) to call it.